Description

Our 60 series Expedition Rear Bumper is similar to our Classic Rear Bumper, but features a fold out ladder for easy roof rack access and RotopaX support. No part of this rear bumper/tire carrier touches your Land Cruiser’s body. Bumper section is built from precision cut, formed 3/16″ plate steel with a tire carrier and jerry can basket/ladder swing-outs are made with 2″x.250″ wall square tubing.The basket feature Hi-lift jack provisions, holes to mount license plate and license plate light, and can hold one jerry can. Features a built-in tow/hitch receiver with chain loops that connects Pivots are precision ground & polished shafting and .250″ wall DOM tubing with replaceable bronze bushings.

3/8″ tire mounting plate will easily handle a fully inflated 37″ tire and is adjustable for wheel width.

D-ring/shackle mounts are 1/2″ thick plate steel.

The ladder can fold all the way down as well as be locked at 90 degrees(great for a small stand/table out in the field.) Features two RotopaX provision points. One on the lower end of the ladder, and one near the top.

Visit RotopaX.com for RotopaX mounting hardware and fuel cans.

Shackle mounting points are reinforced with 1-3/8″x.188″ wall sleeves.

Closes with a Carr Lane Double Cam Clamp.

Hardware is included.  Powder coated satin black.

To install, you must remove your frame’s factory rear cross member, the eight rivets in your rear body mounts, as well as the stock rear bumper mounts(six rivets).

The bumper then slides and bolts into the frame rails and provides even more support than before with our built-in cross bar.